|
|
Instructions For Preparing Your Banner For Your Clipsin Banner
Retaining System
Pictured below is an example of a banner face and the extra banner material
that you will need to install your banner into the ClipsIn Banner Retaining
System.
- You will need to add 7/16” of border to your banner to act as a guide
when inserting your banner into the ClipsIn banner retaining system. This
will ensure that your banner is aligned properly and that your banner is
square. It helps if the extra 7/16” border is a similar color to the actual
copy area. This may also provide a little room to move your banner around
should you find that you need to.
- You will also need an extra 1-1/2” of banner material around the
perimeter of the 7/16” border for the banner to clip into the ClipsIn banner
retaining system. It is this extra banner material that locks into the
retainer, ensuring that your banner will stay in place, and will not slip or
sag.
You can
watch
the video to get more information on how to assemble your ClipsIn
Banner Retaining System.
|
